installed hood louvers after some massaging of hood and louvers on passenger side

installed new ididit box

installed glovebox and lock

removed passenger side door panel and installed the respective outer window felt

adjusted passenger side door window to finished top

fixed a broken roller on front of window and replaced with more appropriate length one after modifications

new ididit ignition relay box blew a fuse internally

tacked wires and found that too many accessories was wired to the same leg on the relay box so the power windows are now on its own separate relay leg

added some major modifications to passenger rear window track to match up to the finished top and finally got it adjusted properly

wired in switches to rear windows nicely in center console so rear windows can be operated without getting out or moving as requested

modified and adjusted drivers side rear window tracks to close nicely to the finished top

marked proper locations for rear seat hold down brackets and are ready to be bonded

reinstalled door panel on passenger side door after that door is finished

hooked up center vents to A/C box

cleaned good trim and rear top trim

installed hood trim

trimmed holes, painted washers, and tightened bolts to inner fenders

adjusted drivers rear window

adjusted drivers door window

bonded rear seat brackets to floor

installed all remaining window felts

finished adjusting passenger side windows

Installed rear door panel

removed back of seat to install the rest of side panel that covers the convertible top

finish adjusted drivers side windows

Installed drivers side panels

installed rear seat and both window crank handles

found any remaining required or missing parts

installed front shocks

installed passenger front seat

fixed hood safety latch

installed new trunk weatherstrip

installed trunk floor plugs

installed windshield pillar weatherstripping

finished a multitude of other small things and adjustments that needed to be done

found that engine was incredibly out of tune. Removed vacuum advance, adjusted timing, adjusted idle mixture significantly, adjusted timing again, adjusted idle speed, reattached vacuum advance

checked transmission fluid level

adjusted alignment for test drive

test drove

adjusted idle mixture with vacuum gauge reference

checked plugs for color

test drove again

prepped header trim panels for fiberglass molding

installed visor brackets

installed rear view mirror

installed horns to front of car

restored steering wheel center cap and horn buttons

tested horn buttons on both sides

improved horn ground

made fiberglass header panel molds

trimmed molds to be read to make new panels

attached fabric convertible top "basket" to rear seat

swapped convertible top outer rear trim to a new set

adjusted clutch pedal throw